Getting started

Thank you for purchasing Supracontrol BIZ-TH100 Temperature and Humidity Controller, a powerful tool for environment control.

 

Installation steps:

Access the Device

BIZ-TH100 can be accessed by connecting it to a PC:

  • Connect the BIZ-TH100 to the Data & Power Out port on your PoE adapter using an Ethernet cable
  • Connect your PC to the Data In port on your PoE adapter using an Ethernet cable
  • Plug the provided PoE adapter into a power outlet
  • Manually set your PC's IP address to 192.168.0.2
  • Open a web browser on your PC, in the address bar enter the default BIZ-TH100 IP address 192.168.0.3
  • Default username and password are both admin
  • You should now have access to your BIZ-TH100 Web Management Console, please proceed to the next step

 

Configure network settings

When you first access your BIZ-TH100 device, it is set to factory default network settings - IP address is 192.168.0.3 and DHCP is disabled.
In order to prepare your device for use on your network:

  • Go to Settings > Network
  • In case you wish to enable DHCP, please read this first
  • Enter your preferred network settings and press the SAVE button (if you do not press SAVE, all changes will be lost)
  • Note: the device will reboot upon changing network settings
  • If the device's IP address has been changed you will need to access the device at its new IP address
  • Your BIZ-TH100 is now ready for network connection

 

Connect the device to your network

BIZ-TH100 requires an external power source. Because of this, there are two options for connecting the device to your network:

1) Your network connection supplies 48V PoE and your BIZ-TH100 is PoE 48V compatible

  • In this case make sure that BIZ-TH100 is properly set up for your network and connect the device to your network using an Ethernet cable

2) Your network connection does not supply 48V PoE

  • Make sure that BIZ-TH100 is properly set up for your network
  • Connect the BIZ-TH100 to the "Data & Power Out" port on your PoE adapter using an Ethernet cable
  • Connect your network connection to the "Data In" port on your PoE adapter using an Ethernet cable
  • Plug the provided PoE adapter into a power outlet

After connecting the BIZ-TH100 to your network you should be able to access it at the IP address specified during network settings configuration.

 

Set up SMTP settings

SMTP settings enable your device to send you notifications via email. To properly configure SMTP settings, please contact your network administrator.

 

Cloud integration

Cloud integration enables you to access your BIZ-TH100 over the Internet from anywhere. In order to set up cloud integration your BIZ-TH100 needs to have Internet access.

Cloud integration is a simple process:

  • Connect to your BIZ-TH100 through your network
  • Go to Settings > General
  • Check the Enable Cloud Service
  • Note: the device will reboot after enabling Cloud Service
  • Go to Menu > Cloud Service
  • Follow the instructions for Cloud Service setup
  • Note: On Supracontrol Cloud Service, Settings are located in the User menu
Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request