Firmware uploader

Install the latest firmware to your Controller using Supracontrol Firmware Uploader:

  • Download the appropriate firmware .hex file for your respective Controller
  • Make sure your PC and Controller are in the same network and that you can access the Controller
  • Ensure that there are no UDP port restrictions on the firewall
  • Run the SC_Firmware_uploader.exe

 

  • Enter your Controller IP address and press Connect

Unos_IP.png

  • The blinking red LED will indicate that the Controller is in firmware upload mode

 

  • Select Load Hex File and browse for the downloaded firmware .hex file

Load_hex.png

 

  • Press Upload and wait until your Controller installs the new firmware

Upload.png

 

  • When the upload finishes, you should see a verification message
  • The green LED indicates that the Controller is operational

Gotovo.png

  • Press Disconnect and exit the application

 

Download Supracontrol Firmware Uploader:

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request